Our support team will be working with limited hours from December 24th to January 2nd. While we’re here to help, response times may be a little longer than usual.
For general troubleshooting of the Grandmother, we recommend the following steps in order:
- Reset all GLOBAL SETTINGS
- Hold down the HOLD and SYNC buttons for three seconds until you see the SYNC button blinking.
- Hold the highest black key (A#2), and while holding it press the lowest black key (F#0). You will see the three buttons on the LHC blink rapidly for a moment to confirm that the reset happened.
Here is a video detailing this process.
- Hold down the HOLD and SYNC buttons for three seconds until you see the SYNC button blinking.
- Perform a NOTE CALIBRATION
- Hold down the HOLD and SYNC buttons for three seconds until you see the SYNC button blinking.
- Once blinking, hold the PLAY, HOLD, and TAP buttons, and then press the lowest white key on the keyboard.
- Hold down the HOLD and SYNC buttons for three seconds until you see the SYNC button blinking.
You can find a video showing this process here.
- Perform a POT CALIBRATION
- Send the necessary sysex files to the instrument via USB. You can find the necessary files and further instruction here.
- Send the necessary sysex files to the instrument via USB. You can find the necessary files and further instruction here.
- Update the FIRMWARE to the latest version.
- You can find files and instructions here.
- You can find files and instructions here.
A guide on how to send sysex files to your synthesizer can be found here.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article