Our support team will be working with limited hours from December 24th to January 2nd. While we’re here to help, response times may be a little longer than usual.
No, there is a good chance that the effect is in Stereo mode, causing it to function abnormally with a standard ¼” audio cable in the output. To correct this is simple, just remove the screws holding the rubber feet and bottom panel to the pedal and check the small switch near the battery compartment. There are markings on the board indicating Mono and Stereo, so make sure that your switch is set to Mono unless you are using a stereo ¼” cable.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article