Our support team will be working with limited hours from December 24th to January 2nd. While we’re here to help, response times may be a little longer than usual.
Because the Voyager XL (and Voyager) hardware is designed the way it is, there is a control input for the Filter Cutoff Frequency, but not the Filter Spacing or Resonance. We had to draw a line as to how many dedicated CV inputs we could include. In the end we chose those inputs that we felt had the most utility and we had to remove a few that were more esoteric.
However, we cleverly designed in a few hooks that provide the Voyager flexibility in routing external CVs to controls that don't have a dedicated CV input. This can allow external control Voltages to control things like Filter Spacing etc.
The MOD1 and MOD2 inputs accept 0 to +5V control inputs. The MOD1 input is the controller for the Pedal/On Mod Buss, normalled to +5V. The MOD2 input is selectable as a Mod Source for both Mod Busses, normalled to +5V.
Note that Filter Spacing can be selected as a Programmable Modulation Destination in either Mod Bus. Thus you could route the MOD2 input to control Filter Spacing through the Mod Busses.
Also, either MOD1 or MOD 2 inputs may be routed using the Voyager's POT MAPPING feature to control any of the front panel knobs, including Filter Spacing or resonance.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article