Our support team will be working with limited hours from December 24th to January 2nd. While we’re here to help, response times may be a little longer than usual.
While there is no direct CV control for the wave folder, this can be approximated in several ways:
- Patch the ATTN out to the ONE (-5) input jack of the mixer.
- Patch VCO out to the TWO input jack.
- Patch the ONE + TWO output to FOLD IN
- Turn the ONE LVL knob at its rightmost position.
- Try patching the LFO out into the ATTN (+5) input and adjusting the LFO rate and attenuator rate knobs to get varying levels of modulation.
___________________________________________________________________________________________________
- Patch the LFO out to the ONE (-5) input jack of the mixer.
- Patch VCO out to the TWO input jack.
- Patch the ONE + TWO output to FOLD IN.
- Turn the ONE LVL knob at its rightmost position.
- Adjust LFO rate
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article